Nose sections are hollow and are direct replacements for the kit parts. No modification to the kit is needed. 

On this ATARS nose, there are small diameter rods going across the forward camera bay. These were added to ensure the forward bulkhead of the bay printed correctly. Carefully remove these using a fine tipped sprue cutter, or sharp X-acto blade. We do NOT recommend using the new ultrasonic cutters on these parts. 

Also included are the following :

Clear Window for camera bay. **Use your preferred Clear Gloss to restore the clarity of the 3D printed part. This gets frosted during the cleaning and curing process. 

Forward nose wheel well bulkhead

2 x pitot tubes

1 x CN18 antenna (not used in this set)

2 x AOA probes

1 x ALR-67 antenna

1 piece to depict the vent on the bottom aft portion of door 3 (not used in this set) 

Nose Landing Gear Doors

Like most of our other items, these will be removed from the print supports prior to curing and packaging. All you will need to do is lightly sand the mating surface to remove the remnants of the support nibs.

CAD by Peter Fidloczky